20
f.
Remove the Power Switch
1. Loosen the securing screws to
detach the bracket.
2. Disconnect the cable of
Power Switch.
g. Disconnect the Touch Panel Connector
Remove the Flat-Wired Cable of the Touch Panel
from the Main Board
The Touch Control Unit is embedded
in the Main Board of POS-3000-i.
Disconnect the flat-wired cable of the
Touch Panel before removing the
Main Board Unit.
Summary of Contents for POS-3000 Series
Page 11: ...11 Figure 6 Main board Layout Back POS 3000 B CFAST Slot...
Page 14: ...14...