13
D
Disassemble the POS Unit
a. Remove the HDD Module
The Securing Screw of HDD Cover
Push leftward and detach the HDD cable
HDD Module (hard disk and HDD cover)
The detached hard disk (left) and
HDD Cover (right)
1. Place the POS unit on a flat,
clean and stable location (desk,
table
…etc).
2. Loosen the securing screw.
3. Pull the HDD cover to the left
and pull out the module.
Disconnect the HDD cables to
remove the HDD module.
4. Detach the HDD from the HDD
cover.
Store them at a secured place.
Remove the HDD securing screws
(on both sides)
from the HDD Cover
