4
Main Board
● Main Board Connection / Installation Notes
The table below is the descriptions of the connectors of the main board.
Each connector/slot is used for the specified part or optional peripheral.
Please refer to the notes as below and examine the layouts of the main boards to locate
the correct connectors so as to complete the installation.
i.e.:
To connect the HDD to the main board, please use the
HDD cable
and locate the
matched connector on the main board; then connect the HDD cable to the Hard Drive.
No. Connector/Slot
Connection/Installation Notes
1
HDD Connectors
Please use the HDD cable and connect to the Hard
drive. (Black: Data; White: HDD power)
2
Connector of Capacitive Touch
Control Unit.
ONLY
when connect to the Capacitive Touch Panel
3
Connector of Side I/O Board
Connect to the Side I/O Board (PS/2 and USB)
4
Connector of Resistive Touch
Control Unit.
ONLY
when connect to the Resistive Touch Panel
5
Connector of PWR Indicator
Connect the Power Indicator to the main board.
6
Connector of Power Switch
Connect the Power Switch to the main board.
7
LVDS Connector
Use the LVDS Cable and connect to the LCD Panel.
8
Audio Connector (Speaker)
Connect the Speaker to the main board.
9-1 Connector of Side I/O (MSR)
Connect the Side I/O Connector (MSR) to the main
board.
*Reserved for MSR/i-Button Module
9-2 Connector of Side I/O (USB)
Connect the Side I/O Connector (USB) to the main
board.
*Reserved for MSR/i-Button Module
10
Inverter Connector
Please use Inverter Cable and connect to the Inverter.
11
RAM Module Slot
Install the RAM module to the main board.
12
CPU FAN Connector
Install the CPU Cooler kit(CPU Fan & Heat Sink)
*For POS-6000-I only
