Assembling the Detector
Toggle
Cable
1.
There are rubber washers between lower rod and loop ears.
2.
Insert lower rod into one end of middle rod so that the spring clip
buttons line up and locks into one of the adjustment holes. Then,
insert the other end of the middle rod into the curved “s” rod so that the
spring clip button lines up and locks into the hole of the middle rod.
3.
Unravel loop cable and wind the cable around the rod assembly.
Plug loop connector into control box and secure the screw finger.
4.
Install batteries as described in the next section.
Installing Batteries
1.
The battery holder holds 8 “AA” sized batteries. Alkaline are
2
