Fanaway EVO1 LED Installation Instructions
11 |
P a g e
AFTER INSTALLATION
WOBBLE:
NOTE
: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber
grommet. If the fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a
few centimetres is quite acceptable and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE:
Please check that all screws which fix the mounting bracket and
down rod are secure.
BALANCING KIT:
A balancing kit is provided to balance the ceiling fan on initial installation. Please
refer to the instruction on how to use the balancing kit.
The balancing kit can be used to assist
re-balancing should the ceiling fan become un-balanced again. Store your balancing kit away after
installation for future use if required.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in
fan motor noise. This is normal. Please allow a 24-hour “settling-in” period, most noises associated with
a new fan disappear during this time.
The manufacturer’s warranty covers actual faults that may develop and NOT minor complaints such as
hearing the motor run – All electric motors are audible to some extent.
CARE & CLEANING
NOTE: Always turn OFF the power at the mains switch before performing any maintenance or
attempting to clean your fan
.
•
Every 6 months periodic cleaning of your ceiling fan is the only maintenance required. Use a soft
brush or lint free cloth to avoid scratching the paint finish. Please turn off electricity power when you
do so.
•
Do not soak or immerse your
ceiling
fan in the water or other liquids. It could damage the motor or
the blades and create the possibility of an electrical shock.
•
Ensure that the fan does not come in contact with any organic solvents or cleaners.
•
To clean the fan blade, wipe with only a damp clean cloth with NO organic solvents or cleaners.
•
The motor has a permanently lubricated ball bearing so there is no need to oil.
