When pairing the remote control with the receiver for the very first time you generally only need to
press and hold the fan ON/OFF button for 5 seconds before it responds. This is the correct
procedure to add a new remote control to a receiver BUT it does not cause the receiver to “forget”
previously paired remote controls. So you could in theory add up to several remote controls to a
receiver.
Pressing and holding the ON/OFF button for a longer period (e.g. 15 seconds) will:
a) wipe the receivers memory (removing any previously paired remote controls)
b) then add the pairing remote cont
rol to the receiver’s memory
This is typically the desired pairing behaviour required.
FUNCTIONS OF TRANSMITTER
TROUBLESHOOTING
TROUBLE
POSSIBLE CAUSE
SUGGESTED REMEDY
Fan will not start
A) Fuse blown or circuit breaker tripped
A) Check fuses and circuit breakers
B) Loose wire connections or plugs to
fan/controller
B) Check wire connections and ensure plugs are
positively connected
C) Battery flat in remote control
C) Replace 12V battery in remote control
Fan wobbles
A) Fan blades are not horizontal to the
ceiling
A) Retighten all screws on blades.
Do not
make any
adjustments by applying pressure up or down on
blades
B) Blade screws are loose
B) Make sure all screws are tightened
C) Blades are not balanced enough
C) Use the provided balancing kit to balance the
blades
Fan sounds noisy
A) Loose fan blades
A) Retighten all screws on blades.
B) Ceiling fan not secured against ceiling
B) Retighten all screws on the mounting bracket
Mechanical noise
A) Fan has not settled in fully
A)
Allow at least 8 hours of use for the fan to
set in
B)
Ensure
