3. Install the Downrod
3.1. Select rod size (12.5cm, 25cm or longer rod if purchased) and open Downrod Screws Bag
3.2. Thread wiring through the rod and insert rod above motor housing.
3.3. Insert Cross Pin (gently wriggle and rotate until it glides through both holes)
3.4. Place Cotter Pin on the other side of the cross-pin to secure the downrod to the motor bush.
3.5. Secure with two screws (removed in 2.2) on either side to make the downrod rigid in the
motor bush.
3.6. Install York
3.7. Place the canopy cover through the rod, then place downrod ball at top of rod.
3.8. Install Holding Screw, then push ball up to fix onto Holding Screw, then use the two screws from
the Downrod Screws Bag to Secure the Ball.
3.2
3.6
3.3
3.7
3.4
3.8.A
3.8.B
INSTALLATION STEPS
Summary of Contents for CFFCHZ3BRR
Page 16: ...WWW FANCO COM AU...
