Fanco CFFCST2LWHSMR, Installation Manual

REVERSE FUNCTION

The “Summer/Winter” reverse function is included in the remote control to make the fan 
rotate in an anti-clockwise direction during summer. 
In winter, this can be reversed, so that the blades now move in a clockwise direction. Press 
and hold “F/R” button for 3 seconds to switch between “Summer” and “Winter modes.

CARE & CLEANING:

• Periodic cleaning (approximately 6 months) of your ceiling fan is the only maintenance 
required.
• Use a soft brush or lint free cloth to avoid scratching the finish. Please turn off electricity 
when you do so.
• Do not use water when cleaning your ceiling fan. It could damage the motor or the wooden 
blades and create the possibility of an electrical shock.
• The motor has a permanently lubricated ball bearing and as such, is maintenance free.

NOISE:

The manufacturer warranty covers actual faults that may develop, but NOT minor 
complaints, e.g. motor operation noise - ALL ELECTRIC MOTORS ARE AUDIBLE TO SOME 
EXTENT; this is more obvious when the fan is operating at low speeds.

WOBBLE:

• Ceiling fans are designed to move during operation because they are not generally rigidly 
mounted
• Movement of a couple of centimetres is acceptable for safe operation.
• Balancing kits included should be used to adjust the balancing when first installed.

NORMAL WEAR AND TEAR:

Threaded components working slighting loose or blade carriers even slightly bent due to 
vigorous cleaning or bumping can cause extra wobble and noise. THIS IS NOT COVERED 
UNDER WARRANTY, but a little care and maintenance can reduce or prevent this problem.

REMOTE CONTROL SETTINGS AND OPERATION FOR DC FANS

NOTE:

The Hand Held Remote Control System is equipped with a learning frequency function 
which has code combinations to prevent potential interference from other remote units. The 
frequency on your Receiver and Transmitter units have been pre-set at the factory. If the 
remotes need programming please following these instructions and use a small size tool to 
change the code switch setting for each remote.

PAIRING THE REMOTE:

All Studio fans are pre-paired and there is no paring process needed to start the fan.
If you want to reset the fan to factory setting. Please follow steps below.
1. Connect power to the fan.
2. Within 10 seconds after turning on the power, short press “ON/OFF” 3 times and hold the 
button for 3 seconds. Then, the fan will beep once and it means it’s paired successfully.
3. Now test the remote by pressing on speeds or light button.
4. It can take up to 10 seconds for the fan to start moving, after pressing a speed button. 
The fan may move a few times slightly backwards and forwards and then will start rotating 
slowly whilst building up to the correct speed. This is normal behaviour for DC fans.

Considerations:
1. If the receiver is not receiving a signal from the remote control: 
a. Please check the battery to ensure it has sufficient power and has been inserted correctly 
and aligns with the positive and negative terminals; or
b. Please check if there are any other similarly remote controlled objects that work nearby, 
as remote controlled items operating on the same frequency may disturb each other.

9