Fanco CFFCST2LWHSMR, Installation Manual

2. If the battery is low it will affect the sensitivity of the remote control and the signal reception 
and must be replaced (the LED indicator light will flash a warning when the battery runs low).
3. Please remove the battery if the remote control is not being used for a long time.
4. if multiple fans are installed near the fan to be paired, power to the other fans should be 
turned off before pairing.

Considerations when installing multiple ceiling fans:

Sometimes you may encounter a remote control issue when installing multiple fans. For the
purposes of this troubleshooting guide: 
Fan A uses Remote control A and Receiver A, while Fan B uses Remote control B and Receiver 
B.

1. Isolate power to one fan only when pairing the remotes

When installing two or more fans, you should manually isolate power to Fan B while 
completing the pairing process on Fan A. If power is not isolated to one of the fans when the 
power is restored at the fuse box, then both receivers will be put into “learning mode” such 
that when you try to pair Remote control A to Receiver A, Receiver B will also be in learning 
mode and might pair to Remote control A too.

FUNCTIONS OF THE TRANSMITTER

10

F/R

P airing:  pres s  “         ” after power s upply,  s hort pres s  3 times  and hold at leas t 

3S  at 4th pres s ,  a "beep" s ound mean pairing s ucces s  (All procedure need to 

be finis hed within 1 0)

F an s peed  

regulator

FA N ON/OF F

Timer 

(1 H-9H)

F /R

 (hold for 3S )

Natural Wind 

L amp ON/OF F

L ight dimmer

(1 -8level luminance)

Tri -color 

convers ion

Pairing Process 

- Press the ON/OFF button 3 times and 

on the 4th press, hold the button down for at least 3 
seconds. A beep sound means that the remote has 
paired sucessfully (complete process needs to be finished 
within 10 seconds).