IntelliTek
Configuring basic settings
6
Only relevant if the portion sizes in this section differ from the portion sizes configured on the PC (e.g.
when other feed is being fed in this section).
In general the calibration of the DosTek dispensers (“portion-sizes” and “water-time”) of the IntelliTek system is
set at the PC and is valid for all DosTek dispensers of the system. However, in case the user wants to feed a
different type of feed at a certain section, he can calibrate the DosTek dispensers of this section individually.
1. Click
Settings
and choose
Calibration of dispenser
. The following screen apprears:
For each DosTek dispenser at the IntelliTek, the “system values” (set at the PC) for “portion-size” and “water-
time” are shown. (If the IntelliTek stations are only equipped with one dispenser the “Dispenser 2” will not be
shown). As long the switch below the “system values” is switched OFF, the system values will be applied for
this section. The user can set individual values for the DosTek Dispensers of this section by switching ON the
“user values” and set them accordingly.
2. Switch
to
to active the user values.
3. Set the calibration values.
Dynamic group
of sows means, that the sows within this section have different stadiums. The section will be
filled with sows sequential (time by time) some days after inseminating. So usually the sows within this section
have different “days of pregnancy”. This section will be always occupied by sows, because only sows that are
ready for farrowing will be removed out of this section.
Static group
of sows means, that all sows within this section have the same stadium. The section will be filled
with all sows (that were inseminated at the same time) at once. So, all sows within this section must have the
same “day of pregnancy”. This section will be complete empty after all sows are removed to the farrowing.
This setting has influence on the handling of the IntelliTek system and should be set carefully.
Summary of Contents for INTELLITEK
Page 1: ...g...
