Lumina 38
Installer
42
Output address
Setting of the analog output address.
Analog type
Setting indicating the analog control type
Pre-run time
Setting of the time in which the air inlets go to the required position, before the fans
activate.
Modulate link
Setting indicating if these air inlets are to be included in modulating ventilation
— if
modulating ventilation is used.
Position wind side
Setting of the compass positions, which represent the wind side of the house. If the
wind comes from this direction (positions), the ventilation control may be influenced.
Position lee side
Setting of the compass positions, which represent the lee side of the house. If the wind
comes from this direction (positions) under wind side, the ventilation control may be
influenced.
INSTALLER
→
HEATING
Description
Setting of the name of the function.
Temp. inputs
Setting the addresses of the analog inputs. If the temperature sensors have not been
assigned, the control computer will use the house temperature.
Control
Setting of the heating control type:
LINEAR
or
RELAY
.
Output address
Setting of the analog output address (choice
LINEAR
control) or relay output address
(choice
RELAY
control).
Relay type
Setting of the type of relay control (
ON/OFF
/
Modulating
).
Analog type
*
Setting indicating the analog control type
Precontrol
Setting indicating if the heat demand should be transmitted to a central boiler control
(precontrol).
Summary of Contents for LUMINA 38
Page 1: ...g...
