Rev. 1.0, 12-22-2011
Fancy Foam Models, LLC
635 Laramie Cir. Maize, Ks. 67101
www.fancyfoam.com
EPP 3Decathlon – Assembly Instructions.
Recommended Electronics and motors:
Motor: Park 250 outrunner or any equivalent motor
Speed control: 6 amp minimum.
Battery: 250 to 450, 2s , 20C rated or equivalent.
Receiver: 4 channel.
Servos: 9gr. for ailerons, and 5gr servos for the tail.
Disclaimer: Fancy Foam Models has done everything
we can to caution and inform the end user regarding
the use of Lithium polymer battery technology. We
are in no way responsible for any damage that may
be caused by these batteries. Please read,
understand and follow all instructions for the
charger and batteries. Failure to use this battery
technology properly can result in the risk of fire. If
you are not comfortable with this technology, return
the batteries packs and kit to us for a refund. By
building the kit and using the batteries, you accept
full responsibility for the safety of these batteries.
Recommended building methods and glues:
Much of the construction of this model is done by laying
the parts on a flat table. It is strongly recommended that
you put wax paper down on the surface first so any excess
glue doesn’t soak through the foam and glue the parts to
the table. For all assembly, use thin “foam safe” CA glue.
Gap filling or “medium” glue just adds weight. Always use
accelerant or “kicker” to get the glue to set. If possible,
apply the glue to one part and the kicker to the other part
and then press them together and hold until cured. Wipe
off any excess glue with tissues before it cures.
Wing Preparation:
Glue the 1x3mm spar into the slot on the bottom of the
wing. Let the spar glue cure for 30 min on a flat surface.
Hinge the ailerons to the wing using the Welders glue
method. (See the video on the web site for more info).
Fuselage Construction:
Hinge the elevator to the horizontal stabilizer.
Glue the horizontal fuselage to the horizontal tail
assembly.
1
