Fuselage to Wing Sub – Assembly:
Lay the wing upside down on the table (vee groves
visible). Locate the front fuselage section and glue it to
the leading edge of the wing. Use a straightedge along
the fuselages slots to align the front fuselage.
Next, locate the fuselage aft section and glue it to the
trailing edge of the wing. Use a straight edge to make
sure the slots are in alignment from nose to tail as the
glue cures.
Elevator Preparation and Attachment:
Locate the horizontal stabilizer and elevator. Apply hinge
tape along the entire length of the elevator hinge. Cut to
length (2.5”) and glue the flat carbon strip to join the
elevator halves as shown.
Glue the stabilizer to the back of the fuselage. Make sure
you take time to make this joint in perfect alignment.
2
Summary of Contents for MX2
Page 8: ...Fancy Foam Models 8...
