- 4 -
1. Unscrew the external sensor cover. Unscrew the 2 screws and
remove the sensor cover (Fig. 1).
2. Disconnect the power supply.
3. Pass the wires through the rubber grommet in the sensor mo-
unting base.
4. Fasten the base with 2 screws to the ground (Fig. 2).
5. Connect according to the diagram.
6. Set the area of the detection field, the sensitivity of the twili-
ght automatic system and the switching time.
7. Assemble the sensor casing (Fig. 3).
When the power is switched on, the motion detector is
inactive for the first 10 seconds.
Mounting
