F&F Fox SHUTTER-D, Manual

- 12 -

In case of lack of access to the controller, for example due to 

lost passwords, it is recommended that you reset the access 

passwords and then reconnect and configure the controller 

using the Fox application.

To reset passwords:
1. While the controller is operating, press and hold the PROG 

button on the front of the controller. When the button is pres-

sed, the green LED will start to flash rapidly.

2. After about 5 seconds, the LED will turn off and you should 

release the PROG button.

3. Press the PROG button briefly, the green LED will light up aga-

in.

4. Press and hold down the PROG button. After about 3 seconds, 

the previously switched on green LED control light will start 

to flash. After another 3 seconds, it will go out and the red 

LED light up.

5. Release the button – after a few seconds the indicator LED will 

turn green and the controller will restart.

6. After completing this procedure, the access passwords and 

parameters for remote access have been cleared. You can 

now search for your device again in the app and personalize 

it again.

Restore factory settings