- 3 -
Connection
L – power supply L
N – power supply N
Do not touch the back of the unit
when the power is switched on.
The configuration of the S2 touch field can be changed to ON and the
configuration of the S4 touch field to OFF. To do this, select the ap-
propriate mode according to the attached table using the knob located
on the housing of the module.
Mode
Input
A
S1
S2
S3
S4
B
S1
ON
S3
S4
C
S1
S2
S3
OFF
D
S1
ON
S3
OFF
Due to the nature of transmission and retransmission, do not use the
same button in the transmitter more often than every 2 seconds. The
switchover of the receiver may take place with a short delay.
Button configuration
It is not recommended to use remote bistable transmitters to control a
group of receivers because of the risk of desynchronization of the swit-
ch-on status (especially in the case of operation at longer distances and/
or simultaneous use of local buttons on receivers).
Summary of Contents for FW-GS-230-B
Page 8: ......
