- 3 -
③
Correct pairing will be confirmed by temporary switching off of the output
circuit and the LED will turn on again.
Each channel of the receiver can be paired with eight different transmit-
ters (remote buttons). Pairing with more buttons will remove the first en-
tries made in the receiver.
Exit from the receiver programming mode will occur automatically after
30 seconds of waiting for a signal from the transmitter or after a short
press of the PROG button.
Unpairing of the remote control from the receiver is possible only by clearing the list of all trans-
mitters in the receiver. To clear the list of transmitters cooperating with the receiver, press the
PROG button and hold it down for at least 10 seconds. Fast flashing of communication LED will
indicate that the memory of the controller has been cleared.
Buttons
We do not recommend the use of remote bistable transmitters to control a
group of receivers due to the possibility of desynchronization of the activation
state (especially when operating on larger distances and/or simultaneous use
of local buttons on the receivers).
Due to the nature of transmission and retransmission do not use the same but-
ton in transmitter more often than every 2 seconds. Switching of the receiver
may be carried out with a short delay
Unpairing
