How to Assemble Your Light Kit Assembly or Cap (Continued)
Figure 6
Light Kit
Light Kit
LED Assembly
Glass
Figure 7
6.
Assemble the LED assembly to the light kit using
the two key slots. Replace the removed screw from
Step 3 and secure all three screws. (Figure 6)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
7.
Secure the glass to light kit by twisting in a
clockwise direction. Twist the glass gradually
until it
snaps on to the light kit.
Do not over-tighten.
(Figure 7)
14
1.
IMPORTANT: Using a full range dimmer switch (not
included) to control fan speed will damage the fan. To
reduce the risk of fire or electrical shock, do not use a
full range dimmer switch to control the fan speed.
(Figure 1)
2.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
3.
Remove the battery cover from remote control by
screwdriver and retain the screw for later. (Figure 3)
Figure 1
Figure 2
For illustrative purposes only
-not
intended to cover all types of controls
MAIN FUSE BOX
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and fan
damage could result.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
How to Operate Your Ceiling Fan
Figure 3
