12
Motor
Assembly
How to Assemble Your Ceiling Fan Blades and Light Kit
Option B--for use with light kit
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1.
Secure the blade to the bottom of the motor
assembly using the 1/4
˝
-20 pan head screw with
lock washer/flat washer. (Figure 1)
HARDWARE USED:
X 12
1/4˝-20
Pan Head Screw
With Lock Washer/
Flat Washer
NOTE:
Periodically check blade hardware and resecure
if necessary.
Figure 2
Figure 3
Figure 4
1/4″-20 Pan Head Screw With
Lock Washer/Flat Washer
(3 each per blade)
Figure 1
Blade
Motor
Assembly
3.
Assemble the switch housing assembly to the
support bracket using the two key slots in the
switch housing assembly. Replace the previously
removed screw and securely tighten all three screws.
(Figure 3)
4.
Remove one of the three screws in the switch housing
assembly. Retain the screw for later and slightly loosen
the remaining two screws. (Figure 4 )
2.
Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 2)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
Switch Housing
Assembly
Switch Housing
Assembly
