How to Assemble Your Ceiling Fan
2.
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger
ball for reinstallation in Step 7. (Figure 2)
3.
Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 5. (Figure 3)
Figure 3
Figure 4
4.
Loosen the two set screws and locking nuts in
the downrod support of the motor assembly. Route
the
black, white and blue
wires through the downrod.
(Figure 4)
Downrod
Set Screws (2)
Black, White
and Blue wires
1.
Remove and discard the six rubber motor stops
from the motor assembly by removing the screws.
(Figure 1)
7
Figure 2
Motor Stop
Figure 1
Motor Assembly
Pin
Downrod
Hanger Ball
Set Screw
