7
How to Assemble Your Ceiling Fan (continued)
6.
Figure 5
Figure 6
Housing Ring
Assembly
Fan Motor
Assembly
Assemble the housing ring assembly through
the motor assembly. Slightly loosen the three
screws. Assemble the housing ring assembly
to the light plate assembly using the three key
slots. Twisting in clockwise direction and securely
tighten all three screws. (Figure 6).
Figure 7
Figure 8
Figure 9
Canopy
Canopy
Downrod
Downrod
Set Screw
Hanger Ball
Canopy Screw
Cover
Motor Coupling
Cover
Black, Blue &
White Leads
Black, Blue &
White Leads
7.
Route wires through motor coupling cover, canopy
screw cover and canopy (Figure 7).
8.
Reinstall the hanger ball on the downrod as
follows.Route the three 80-inch wires through the
hanger ball. Position the pin through the two holes
in the downrod and align the hanger ball so the pin
is captured in the groove in the top of the hanger
ball. Pull the hanger ball up tight against the pin.
Securely tighten the set screw in the hanger ball.
9.
Cut off excess lead wire approximately 6 to 9
inches above top of the top of the downrod. Strip
insulation off 1/2-inch from the end of each lead
wire (Figure 9).
NOTE:
All set screws must be checked, and retightened
where necessary, before installation.
A loose set screw could create fan wobble (Figure 8).
