9
Installing the Canopy Housing (continued)
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the key slot twist-lock feature. (Figure 14)
Figure 14
CANOPY SCREW
COVER
How to Assemble the Blades
1. Remove and discard the
five
rubber motor stops
from the motor assembly by removing the screws.
(Figure 15)
Figure 15
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade arm. With
a Phillips screwdriver, tighten 3/16-24x7.5 mm phillips
head screws with flat washers to secure the blade to
the blade arm. (Figure 16)
3/16-24 x 7.5mm Phillips
Head Screw and Flat
Washer (3 each per blade)
BLADE
BLADE HOLDER
Figure 16
HARDWARE USED:
3/16-24 x 7.5 mm
PHILLIPS-HEAD
SCREWS
X 15
FLAT WASHER
X 15
3. Attach blade holders to the motor hub using the
1/4-20x14 mm screws. (Figure 17)
NOTE: Periodically check blade holder hardware and
resecure if necessary.
BLADE
HOLDER
1/4-20 x 14 mm
SCREWS
(2 per assembly)
Figure 17
HARDWARE USED:
1/4-20 x 14 mm
SCREWS
X 10
CAUTION
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
