Fanimation Edgewood TF900 Series, Owner'S Manual

Assembling and Mounting the Fan Blades

1.

 Lay flat side of blade holder arm on a flat surface with 

the inside of the blade holder arm facing up.  This is the 
side with the threaded posts and pitched foot.

2.

 Position the blade over the blade holder with the threaded 

posts showing. Make sure the bottom edge of the blade is 
fully seated against the blade holder arm. 

3.

 With a Phillips screwdriver, tighten screws with flat 

washers to secure the blade. (Figure 1) 

4. 

Attach Blade Holders to the Motor Hub using the Screws 

w/Lock washers as shown in Figure 2.

5. 

Make sure the screws with lock washers securing the 

Blade Holders to the Motor Hub are tight and that the 
Blade Holders are properly seated. (Figure 2)

NOTE:

  Periodically check Blade Holder hardware and re-

secure if necessary. (see Maintenance)

Figure 2

8

INSTALLATION NOTE

Do not connect fan blades until the fan is completely 

installed. Installing the fan with blades assembled may 

result in damage to the fan blades.

Blade

Blade Holder 

Arm

Figure 1

▲

WARNING

To reduce the risk of personal injury, do not bend the 

blade holders when installing, balancing the blades or 

cleaning the fan. Do not insert foreign objects in between 

the rotating blades.