Fanimation FP8000-220 The Akira, Owner'S Manual

9

How to Assemble the Blades and Light Kit

x  16

x  16

FIBER WASHER

3/16-24  x 7.5mm

WASHER HEAD

SCREWS

HARDWARE USED:

x  11

1/4-20 x 14mm

SCREWS

HARDWARE  USED:

BLADE

3/16-24 x 7.5mm WASHER

HEAD SCREW AND FIBER

WASHER (3 each per blade)

BLADE HOLDER

Figure 17

MOTOR SUPPORT

1/2-20 x 14mm SCREWS

(2 per assembly)

BLADE HOLDER

Figure 18

SUPPORT

BRACKET

HOUSING LIGHT

KIT ASSEMBLY

Figure 19

1.

Position  the  blade  over  the  blade  holder  with

threaded  posts  showing.  Make  sure  the  bottom

edge of the blade is fully seated against the blade

arm. With a Phillips screwdriver, tighten 3/16-24 x

7.5 mm washer head screws and fiber washers to

secure the blade to the blade arm (Figure 17).

2.

Secure  the  blade  holders  to  the  motor  support

using the 1/4-20 x 14 mm screws through the holes

located on the side of the motor support (Figure 18).

NOTE:

Periodically  check  blade  holder  hardware  and

resecure if necessary.

3.

Remove  one  of  the  three  screws  in  the  support

bracket  at  the  bottom  of  the  motor  assembly.

Slightly  loosen  the  remaining  two  screws.

Assemble  the  housing  light  kit  assembly  to  the

support  bracket  using  the  two  key  slots  in  the

socket plate. Replace the third screw and securely

tighten all three screws (Figure 19).

Do not connect fan blades until the fan is completely

installed.  Installing  the  fan  with  blades  assembled

may result in damage to the fan blades.

CAUTION

To reduce the risk of electric shock, disconnect the 

electrical supply circuit to the fan before installing

light kit.

CAUTION

To reduce the risk of personal injury, do not bend the

blade  holders  when  installing,  balancing  the  blades

or cleaning the fan. Do not insert foreign objects in

between the rotating blades.

WARNING

!

SCREWS (3)

MOTOR

ASSEMBLY