9
How to Assemble the Blades and Light Kit
x 16
x 16
FIBER WASHER
3/16-24 x 12.5mm
WASHER HEAD
SCREWS
HARDWARE USED:
BLADE
3/16-24 x 12.5mm WASHER
HEAD SCREW AND FIBER
WASHER (3 each per blade)
Figure 1
Figure 2
MOTOR
ASSEMBLY
UPPER LIGHT
KIT PLATE
Figure 3
1.
Slide blade through slot and secure using
3/16-24x12.5 mm washer head screws and
fiber washers (Figure 1).
2.
Remove one of the three screws from the
Housing Support Bracket. Loosen the remaining
two screws without fully removing. Connect the
2-pin connector from the Upper Light Kit Plate to
the 2-pin connector from motor assembly
(Figure 2).
3.
Assemble the Upper Light Kit Plate to the
Housing Support Bracket by aligning key slots
in Plate with the two screws in Support Bracket.
Assemble screw removed in step 2 and tighten
all three screws (Figure 3).
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
SUPPORT
BRACKET
SCREWS (3)
MOTOR
ASSEMBLY
SCREWS (3)
MOTOR ASSEMBLY
2-PIN CONNECTOR
LIGHT SOCKET 2-PIN
CONNECTOR
UPPER LIGHT
KIT PLATE
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
