Fanimation HF6050 Series, Owner'S Manual

This Manual is Designed to Make it as Easy as Possible for You

to Assemble, Install, Operate, and Maintain Your Ceiling Fan

Unpacking Instructions

For your convenience, check-off each step.  As each step is completed, place a check mark.  This will ensure that all 
steps have been completed and will be helpful in 

fi

 nding your place should you be interrupted. 

Wiring outlet box and box connectors must be of type 

required by local code.  The minimum wire would be a 3-

conductor (2-wire with ground) of the following size:

NOTE:

  Place the parts from the loose parts bags in a small 

container to keep them from being lost.  If any parts are missing, 

contact your local retailer.

Tools Needed for Assembly

Materials

Wire Size A.W.G.

Installed Wire Length

14

12

Up to 50 ft.

50 - 100 ft.

NOTE:

  If you are uncertain of part description, refer to

exploded view illustration. (Figure 1, page 13)

3

1. 

Check to see that you have received the following 

parts: 

Receiver Unit

Hardware Bag

Fan Motor Assembly

Downrod/

Hanger Ball

Assembly

Hanger Bracket

• One Phillips head screwdriver
• One stepladder
• One ¼

˝

 blade screwdriver

• One wire stripper
•

Three wire connectors

  (supplied)

Ceiling Canopy

Motor Coupling

Cover

▲

WARNING

Do not install or use fan if any part is damaged or 

missing.  This product is designed to use only those 

parts supplied with this product and/or any accessories 

designated specifically for use with this product by 

Fanimation.  Substitution of parts or accessories not 

designated for use with this product by Fanimation could 

result in personal injury or property damage.  Contact 

your retail store for missing or damaged parts.

▲

WARNING

Before assembling your ceiling fan, refer to section on 

proper method of wiring your fan (page 4).  If you feel you 

do not have enough wiring knowledge or experience, 

have your fan installed by a licensed electrician.

C20 Remote

Control

Blade Holder (5)

• Fan Motor assembly

• Five Blade Holders

• Five Wood Blades

• Hanger Bracket

• Downrod/Hanger Ball

  assembly

• Downrod Cover assembly

• Ceiling Canopy

• Motor Coupling Cover

• Switch Cup Cover

• C20 Remote Control

• Receiver Unit

• Hardware bags:

  – Two 5/32

˝

 threaded rods

  – Two 5/32

˝

 lockwashers

  – Two knurled knobs

  – Two 5/32

˝

 Flat head screws

  – Sixteen 3/16

˝

 screws

  – Sixteen 3/16

˝

 fiber washers

  – Eleven 1/4

˝

 screws

  – Four wire nuts

  – Support Safety Cable bag

  – Phillips screwdriver, 4

˝

  – Balance Kit

Switch Cup Cover

Downrod Cover Assembly

Wood Blade (5)