Fanimation HF6050 Series, Owner'S Manual

7

How to Assemble Your Ceiling Fan (cont’d)

8. 

Route wires & cable through opening in Canopy.  Position 

Canopy on fan shown with open side facing up. (Figure 4) 

9. 

Reinstall the Hanger Ball (Figure 3) on the Downrod 

as follows.  Route the three 80

˝

 wires through the Hanger 

Ball.  Position the Pin through the two holes in the Downrod 
and align the Hanger Ball so the Pin is captured in the 
groove in the top of the Hanger Ball.  Pull the Hanger Ball 
up tight against the pin. 

Securely tighten the setscrew 

in the Hanger Ball.  A loose setscrew could create fan 
wobble.

10. 

The fan comes with black and white leads.  Before 

installing fan, measure up approximately 6-9 inches above 
top of Downrod/Hanger Ball Assembly.  Cut off excess wire 
and strip back insulation ½

˝

 from end of wire.

10.

 You have now completed the assembly of your new 

ceiling fan.  You can now proceed with the hanging and the 
electrical wiring of your fan.

▲

WARNING

It is critical that the clevis pin in the downrod support is 

properly installed and the setscrews & nuts are securely 

tightened.  Failure to verify that the pin and setscrews 

are properly installed could result in the fan falling.

Figure 4

Downrod/Hanger

Ball Assembly

Canopy