7
How to Assemble Your Ceiling Fan
1.
Prior to assembly, set aside and save the hardware
bag(s) packed in the packing.
2.
Remove the hanger ball by loosening the setscrew
in the hanger ball until the ball falls freely down the
downrod (Figure 1). Remove the pin from the downrod,
then remove the hanger ball. Retain the pin and
hanger ball for reinstallation in Step 6.
3.
The fan comes with blue, black, and white 80˝
wires. Separate and untwist the three wires. Route the
wires through the downrod.
Figure 1
Hanger Ball
Pin
Set Screw
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
4.
Loosen the two setscrews in the downrod support.
Align the clevis pin holes in the downrod with the
holes in the downrod support. Install the clevis pin
and secure with the hairpin clip. (Figure 3) Be sure to
push the straight leg of the hairpin clip through the
hole near the end of the clevis pin until the curved
portion of the hairpin clip snaps around the clevis pin.
The hairpin clip must be properly installed to prevent
the clevis pin from working loose. Pull on the downrod
to make sure the clevis pin is properly installed.
NOTE:
The setscrews must be properly installed as
described above, or fan-wobble could result.
5.
Route wires through opening in canopy. Position
canopy on fan shown with open side facing up.
(Figure 2)
6.
Reinstall the hanger ball (Figure 2) on the downrod
as follows. Route the three 80˝ wires through the
hanger ball. Position the pin through the two holes in
the downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin.
Securely
tighten the setscrew in the hanger ball. A loose
setscrew could create fan wobble.
NOTE:
You will be using either the 6˝ downrod
supplied with your fan or an optional downrod
purchased seperately.
Figure 2
Set
Screw
Ceiling
Canopy
Pin
Downrod