8
How to Assemble Your Ceiling Fan (Continued)
Figure 3
8.
Slide the motor coupling cover down until it touches
the top of the motor.
9.
The fan comes with blue, black, and white leads.
Before installing fan, measure up approximately 6-9
inches above top of downrod/hanger ball assembly.
Cut off excess wire and strip back insulation ½˝ from
end of wire.
10.
You have now completed the assembly of your
new ceiling fan. You can now proceed with the
hanging and the electrical wiring of your fan.
Ceiling
Canopy
Motor Coupling
Cover
Hairpin Clip
Downrod
Support
Downrod/Hanger
Ball Assembly
Clevis Pin
Set Screw
WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
7.
While pulling up on the hanger ball, securely tighten
the two 3/16-24 x 3/8˝ setscrews in the downrod
support. (Figure 3)
