10
Mounting the Cover Switch Housing
Maintenance
Blade Cleaning
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth to
avoid scratching the
fi
nish.
Abrasive cleaning agents are not required and should be
avoided to prevent damage to
fi
nish.
Periodic light dusting of the Palm Leaf, Woven Bamboo,
Wicker, and Wooden blades is recommended. A feather
duster will work best.
Avoid using water, cleansers, or harsh rags, which can
warp and ruin the blades.
Switch Cup
Housing
Cover Switch
Housing
Cover Screws
Figure 17
1.
Position the Cover Switch Housing over the Switch
Cup Housing.
2.
Thread the two Cover Screws into the threaded posts
located in the Switch Cup Housing.
3.
With a Philips screwdriver, tighten screws to secure the
Cover Switch Housing. (Figure 17)
How to Install the Wood Blade Holders
Blade Holder
Screw
(2 per blade holder)
Blade Holder
Screw (3 per blade)
4.
Attach blade holders to the rubber flywheel using the
flywheel screws.
5.
Make sure the screws securing the blade holders
to the flywheel are tight and that the blade holders are
properly seated on the flywheel. (Figure 16)
1.
Lay the side of the blade holder on a flat surface with
the inside of the blade holder facing up. This is the side
with the threaded posts.
2.
Position the wood blade (B4000 Series only) over the
blade holder with the threaded posts showing. Make sure
the bottom edge of the blade is fully seated against the
blade holder.
3.
With a Philips screwdriver, tighten screws to secure the
blade. (Figure 15)
Figure 15
Figure 16
Flat Washer
(3 per blade)
INSTALLATION NOTE
Attach the Blades to the Rubber Flywheel using the
holes marked #4 for 4-blade application.
CAUTION
Do not use water when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of electrical shock.
