REV
U/L
D/L
FAN OFF
OFF
ON
LOW
MED
HI
3
This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Ceiling Fan
Unpacking Instructions
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in
fi
nding your place should you be interrupted.
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
NOTE:
Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
Tools Needed for Assembly
Materials
•
One Phillips head screwdriver
•
One stepladder
•
One 1/4” blade screwdriver
•
One wire stripper
•
Three wire connectors
(supplied)
DAMP LOCATION CEILING FAN:
If you have purchased a
Damp Location Ceiling Fan, you may only use light kits marked
suitable for use in damp locations.
Wire Size A.W.G.
Installed Wire Length
14
12
Up to 50 ft.
50 - 100 ft.
NOTE:
If you are uncertain of part description, refer to
exploded view illustration. (Figure 18, page 13)
1.
Check to see that you have received the following
parts:
• 2 Blade Holder packs containing:
– Five blade holders (used with Traditional blades)
– Four blade holders (used with B4000 Wooden blades)
• Hardware bag:
– Eleven (Trad. & Wood - blade holder to
fl
ywheel)
screws
– Thirteen screws &
fl
at washers to mount wooden
blades to Wood blade holders
– Two 5/32” threaded rods
– Two 5/32” lockwashers
– Two knurled knobs
– Three wire connectors
– Eleven screws (for use with Side A and Side B of the Trad. blade holder)
– Fanimation screwdriver
• Support Cable bag:
– Ceiling Support Cable
– Cable Clamp
–
˝
x 2
˝
Lag Bolt
–
˝
Washer
• C22 Hand-held Remote Control
• C23 Wall Control
• Remote Module Unit
• Fan Motor assembly
• Cover Switch Housing with two screws
• Downrod/Hanger Ball assembly (DR6)
• Ceiling Canopy & Hanger Bracket pack
Hanger Bracket
Assembly
Side A
Fan Motor
Assembly
Hardware Bag
Ceiling Canopy
Remote Module
Unit
C23 Wall
Control
Traditional
Blade Holders
(Set of 5)
C22 Remote
Control
Side B
Wood
Blade Holders
(Set of 4)
Cover Switch Housing
Downrod/
Hanger Ball
Support Cable Bag
▲
WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
▲
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 4). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
