10
How to
Install Your Canopy Housing
2.
Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
NOTE: This step is applicable after the neccessary wiring
is completed.
Ceiling Canopy
Canopy Screw
Cover
1.
Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
Figure 1
Figure 2
How to Assemble Your Ceiling Fan Blades
1.
Position the blade over the blade holder of motor
assembly with threaded posts showing. Make sure the
bottom edge of the blade is fully seated against the
blade holder. Place blade plate over the blade with holes
aligned and assemble blade to blade holder of motor
assembly using
Ý
serrated head screws. (Figure 1)
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
x 9
x 3
BLADE PLATE
HARDWARE USED:
ß
SERRATED HEAD
SCREWS
Blade
Blade Plate
Figure 1
Motor
Assembly
Blade
Holder
