10983 Bennett Parkway
Zionsville, IN 46077
(888) 567-2055
FAX (866) 482-5215
Outside U.S. call (317) 733-4113
Visit Our Website www.fanimation.com
1.
Assemble two (provided) Threaded
Rods on the Crossbar. (Figure 1)
2.
Mount assembled Crossbar to
junction box with screws (provided
with your junction box) (Figure 2).
3.
Securely connect the bare copper
(Ground) wire to the (hex-head)
screw located on the Crossbar.
Securely connect the white lamp
wire to the white supply (neutral)
wire using wire nut supplied.
Securely connect the black lamp
wire wire to the black supply (hot)
wire using wire nut supplied.
(Figure 3)
5.
Carefully fasten hex nut onto
the threaded rod while supporting
Rubber Washer and Glass Bowl
(sold seperately), do not over
tighten. (Figure 5)
Copyright 2004 Fanimation
Figure 1
Figure 2
Figure 3
Figure 6
Figure 5
Figure 4
4.
After connections have been
made, carefully push leads into the
outlet box. Carefully fasten the
Fixture over the Threaded Rods
with the Lockwashers and Knurled
Nuts provided. Install light bulbs (not
included, 60 watt max each).
(Figure 4)
NOTE:
Be sure that the electrical
wires are completely inside the
junction box and not pinched
7.
You have now completed the
assembly of your Semi Flush ighting
fixture. Restore power and operate
your light fixture with your standard
on/off light switch.
6.
Fasten Bowl Cap onto the
threaded rod with Finial Nut.
2004/12