11
Figure 1
Figure 2
How to Install Your Canopy Housing
NOTE: Supply wires and fan wires omitted for clarity.
NOTE:
This step is applicable after the neccessary
wiring is completed.
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
1.
Screw in two threaded rods into the hanger bracket.
(Figure 1)
NOTE:
The threaded rods in the hanger bracket
serves as guides for easier installation.
2.
Securely attach the canopy housing to the hanger
bracket using the external lockwashers and knurled
knobs supplied with your fan. (Figure 2)
1.
Remove and discard the (rubber) motor “stops” by
removing the screws. (Figure 1)
Blade & Blade Holder Assembly:
2.
Lay the side of the blade holder on a flat surface
with the inside of the blade holder facing up.
3.
Assemble the blade to the blade holder with the
carriage nuts, flat washer, and screws. Make sure that
the blade is fully seated against the blade holder.
4.
Tighten screws with a screwdriver provided, don’t
over tighten. (Figure 2)
Lockwashers (2)
Knurled Knobs (2)
Threaded Rods (2)
How to Assemble Your Ceiling Fan Blades and Switch Housing
Motor Assembly
Blade
Blade
Holder
Figure 1
Figure 2
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
X 24
3/16
”
-24
Screws
Flat washers
X 24
3/16
”
-24
Carriage Head Nuts
X 24
HARDWARE USED:
INSTALLATION NOTE
