12
How to Assemble Your Ceiling Fan Blades and Switch
Housing (Continued)
Screw (2 per blade
holder)
Figure 3
Figure 4
5.
Attach assembled blades and blade holders to the
motor hub using the provided screws and lock
washers. (Figure 3)
6.
Make sure the screws securing the blade holders to
the motor hub are tight and that the blade holders are
properly seated.
X 8
1/4
”
-20
Screws
HARDWARE USED:
Housing Switch Cup/Adapter Assembly:
7.
Disassemble the Housing Switch Cup/Adapter
assembly by removing three screws. (Figure 4)
8.
Remove one of the three screws in the support
bracket. Attach the switch cup support cover to the
support flange by rotating plate and properly
positioning screws in key slots. Install third screw in
remaining hole. Fully tighten all three screws.
(Figure 5)
9.
Securely attach 9-pin connector from motor
assembly to wiring harness socket within switch cover
assembly. (Figure 6)
10.
Assemble the Housing Switch Cup onto the
assembled Adapter with three screws. (Figure 7)
11.
Restore Power and your fan is now wired to be
turned on and off from the fan pull chain speed control.
Figure 5
Figure 6
Figure 7
WARNING
The color label on these two connectors must
correspond to each other.
