Figure 1
How to Assemble Your Ceiling Fan Blades
1.
Carefully slide the blade through the slot as shown.
Securely fasten the five blades with serrated head
screws with flat washers. Do not over-tighten.
(Figure 1)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
ʆ
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
HARDWARE USED:
x 15
x 15
FLAT WASHER
ß
SERRATED HEAD
SCREW
Ý6HDG
Screw with Flat Washer
(3 per blade)
Blade
4.
Once the connection has been made, slide the
receiver into the hanger bracket, taking care not to
pinch the wires. (Figure 5)
How to Wire Your Ceiling Fan (continued)
How to Install Your Canopy Housing
2.
Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
WKHNH\VORWWZLVWORFNIHDWXUH)LJXUH
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
1.
Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
NOTE: This step is applicable after the neccessary
wiring is completed.
Ceiling Canopy
11
Canopy Screw
Cover
Receiver
+DQJHU%UDFNHW
Figure 5
Figure 1
Figure 2
