3. ASSEMBLING & OPERATING INSTRUCTIONS
2. PRODUCT DESCRIPTION & SPECIFICATIONS
SPEC
750mm
A
820
B ~ C
1188~1588
D
710
3. ASSEMBLING & OPERATING INSTRUCTIONS
Remove the appliance from the carton. If the appliance is damaged, please
contact Fanmaster or where you purchased the appliance from.
Environment of Use
1.
The max relative humidity is 90% (when in 25°C).
2. Below 1000 metres altitude.
Maintenance
1. To ensure prolonged safe use ensure you have this unit inspected, cleaned &
moving parts lubricated by a qualified person after every 1000 hours of use.
2. Regularly inspect the cord & plug & do not use if damaged. A license electrician
is required to repair or replace the cord & plug.
3.
Any other repairs or maintenance must be performed by a qualified person.
1. Place the fan on an even surface (pedestal).
2. Wall Fan J bracket - this can be installed up or down, ensure the long lock bolt is
always installed the top - refer to drawing.
3. Connect the plug to the relevant power source.
4. The fan is not suitable in environments that is too moist or corrosive.
5. The fan has 3 speeds which can be changed by rotating the speed control
switch. The numbers 0, 1, 2 and 3: 0 = OFF, 1 = Slow, 2 = Medium, 3 = Fast speeds.
6. Oscillation Control: The oscillating function is show in the assembly drawing, it can
be adjusted between 0°~90°. When the adjustment screw is moved towards the
direct shaft, the fan will not oscillate. The further away the adjusting screw is to
the direct shaft, the bigger the oscillating angle.
Operating Instructions
