MECHA IR Remote Commander and Receiver
v.01
6
© 2021 FANOTEC
Functions
The buttons of IR Remote Commander have functions similar to those of the
equivalent buttons on C1 and C2 Controllers.
Power Button
●
P
The power button has many functions and can be used as follows:
○
To power off MECHA:
→
Long press is required, unless otherwise set on the
Configuration
page.
→
If the checkbox
Double press the Nodal Ninja IR Remote Power
button for power OFF
is checked on the
Configuration
page, press
the power button twice to power off MECHA.
To power on MECHA, use the
P
button on the C1 or C2 Controller used.
○
To confirm or cancel some operations, for example:
→
If you enter a code and notice on C2’s display or on C1’s LEDs that
the code is wrong, before specifying the direction, you can cancel
the code with the power button and enter the code again.
○
Use the power button to exit the C2’s Menu Mode.
○
Use the power button to check the battery level when MECHA is idle.
○
It is also the equivalent of the number 0 (zero) when power codes are
entered.
Power codes are codes that start with zero. They can be used as
shortcuts for executing a preset. For example, you can execute the
preset
01 PresetName
very easily with the
P1
button combination.
Please note that the power button,
P
, can always be used as an
emergency stop, if necessary, except for the
speed calibration
procedure (code: 123123<).
!
