Fanstasy Spas ELUSION, Owner'S Manual

9

CONFIGURING SYSTEM 

SELECTING THE VOLTAGE FOR YOUR SPA

Your spa is designed to operate at either 110V 15 amp or 220V, which requires a dedicated 220 

volt 40 amp power supply. When the spa is setup for 110V, the heater will provide approximately 

1000 watts of heat only when the pump is operating in LOW speed and the thermostat is calling 

for heat (NOTE: The heater does not operate when the pump is on high speed). When the spa is 

connected to 220 volts, the heater will provide approximately 4000 watts of heat when the pump is 

operating in LOW or HIGH speed and the thermostat is calling for heat. All electrical connections 

must be made in accordance with the wiring information contained on the electrical control box 

cover.

110 VOLT INSTALLATION

Spas come with a factory-installed power supply GFCI cord and are to be plugged into a grounded 

type 115 volt, 15 ampere receptacle. No other electrical appliance or fixture can be used on this 

circuit.

IMPORTANT:

 Under 

NO

 circumstances should an extension cord be used. Use of an extension 

cord will seriously degrade the performance of the equipment and can create an electrical hazard.

220 VOLT INSTALLATION

When converting the spa to 220V, Dip Switch 10 must be set to the down position. A jumper wire 

from J11 to J32 must also be removed. See following page for 220V Installation instructions.

MODE OPTION (DIP SWITCH 7 SETTING) 

The spa has been pre-programmed to operate in the Standard Operational Mode ONLY. The 

spa may be configured to have three operational modes. To change your spa to allow 3 different 

modes, we recommend you contact Customer Service. Dip Switch #7 on the power supply board 

must be moved down into the “off” position allowing you to select either Standard, Economy, or 

Sleep modes using the topside control panel (see page11)

ELECTRICAL REQUIREMENTS

ON/UP

Dip Switches 2 & 7 UP

1   2   3   4   5   6   7   8   9  10

Dip Switches 2,7 & 10 UP

1   2   3   4   5   6   7   8   9  10

OFF/DOWN

110V Input Voltage

220V Input Voltage

Jumper Wire J11 - J32