2
EyeGrabber Canon G Series Instruction Manual 20110615
Flex arms, while shorter screws are compatible with narrower arms, such as Ball & Joint arms. Choose the
proper set of screws for your system and leave the screws installed only inside the front part of the T2
Connector (image #1). Keep the other set of screws in storage for future use, in case you replace the arms used
in your system.
d.
If assembling the
EyeGrabber
on a Flex arm, gently rotate the links of the
arm so that two sequential holes positioned on the upper half of the arm
are aligned in a way that enables inserting screws inside (image #2). If
assembling the
EyeGrabber
on a Ball & Joint arm, simply choose two slots
on the upper half of the arm which the
EyeGrabber
will be assembled
through.
e.
Hold the front part of the T2 connector with the two screws installed inside in front of the arm, so that the
screws are aligned with the two holes or slots in the arm. Insert the screws through the holes or slots of the
arm (image #3). Any resistance encountered might be due to improper alignment of the holes on the Flex arm
or due to the resistance of the Nylon support line found inside the Flex arm. In such a case, please repeat step
1c and make sure the support line doesn’t get in your way.
f.
Hold the rear part of the T2 Connector on the other side of the arm, so the narrow side of it is facing the arm
and aligned with the screws (the flared side with conical holes should be facing outward). Insert the screws
into this part of the connector as well and tighten them until both sides of the T2 Connector are stable on the
arm (image #4). If the screws are too short to reach the end of the rear connector, replace them with the set
of longer screws. If the screws are too long and stick out from the back of the connector, replace them with
the set of shorter screws.
Image #1
Image #2
Image #3
Image #4
