Part No. INST-ECE150
07/07
Installation:
1. Installation of this product should be carried out by appropriately qualified persons.
2. Cut a hole in the roof 150mm minimum (with regard to roof pitch angle) diameter. The hole should
be positioned adjacent to a rafter or other member to facilitate the use of the duct support straps
supplied. Ensure a clean edge.
3. Cut the rubber roof flashing supplied for 140mm diameter through roof duct.
4. Slide the flashing over the through roof duct to the required position.
5. Check the fit of the duct in the cut hole. The duct must be positioned vertically.
6. If satisfactory fasten the duct to the rafter or other member using either the duct support straps
provided.
7. Fit the flashing to the metal deck using the mounting screws provided.
8. Plug fan into an adjacent power outlet
9. Test run the fan. Check for excessive vibration.
10. The fan through roof duct is designed for connection to 150mm duct using duct tape or clamps.
Installation on Tiles:
