109
109
CHAPTER 18
ENGINE
WORKSHOP MANUAL
TL 250
18.4.13 Assemble the cylinder head cover
Insert the intake and exhaust rocker arms in the cylinder head
cover in the direction shown by the arrows before pushing
them through the cover, matching them up with the intake and
exhaust rocker arm shaft holes.
As the arrow shows, they are at a tangent to the rocker arm
shaft. Keep the tangents pointing towards the upper holes
in the head cover during the rocker arm shaft's assembly.
Next, insert the rocker arm shaft locating plate on the head
cover and tighten the bolt.
Insert the rocker arm shaft with the tangent side facing the
hole in the head cover. Once the head cover has been fitted,
turn the rocker arm. The rocker arm must be able to turn
freely, without requiring any effort.
Torque setting:
Rocker arm shaft setting plate bolts 16 ~ 20 Nm
(1.6 ~ 2 kgf·m, 11.8 ~ 14.7 lbf·ft)
13.4.14 Install the cylinder head
Remove the head's old gasket and install a new one over the
locating stud.
Install the cylinder head, fit the washers and nuts.
Be careful no dust or foreign objects get inside the cylinder.
Torque setting:
Nuts on pin for fastening head to engine
55 ~ 60 Nm (5.5 ~ 6 kgf·m, 40.5 ~ 44.2 lbf·ft)
Insert the cylinder-cylinder block M6×25 bolts in the holes and
tighten them.
Torque setting:
Bolts fastening head to cylinder block
11 ~ 13 Nm (1.1 ~ 1.3 kgf·m, 8.1 ~ 9.6 lbf·ft)
Install the camshaft on the head before fitting the cam chain on
the camshaft sprocket, then check that timing is set correctly.
If it is not, adjust until it is set correctly.
Summary of Contents for TL 250
