123
123
CHAPTER 18
ENGINE
WORKSHOP MANUAL
TL 250
18.6 GENERATOR, CRANKSHAFT BALANCING AND DRIVEN GEAR
18.6.1 Remove the crankcase cover on the left side
Remove the bolts fastening the cover on the front and left
and remove the left side crankcase cover.
18.6.2 Remove the generator stator
Remove the two M5×10 screws from the sensor.
Remove the two M5×30 screws from the stator coil and remove
the generator stator assembly from the left side crankcase cover.
18.6.3 Remove the generator rotor
Remove the lock nut from the magnet rotor and remove the
rotor using the special tool.
You must only use the special tool to remove the rotor.
Do not hammer the rotor.
If the magnet is knocked accidentally during removal or
assembly - for instance, if it is dropped or if a foreign object
bangs against it - replace it.
18.6.4 Remove the balancer drive gear and driven gear
Remove the cam chain and chain tensioning plate before
removing the lock nut and washer from the balancer drive gear.
Remove the crankshaft gear and balancer drive gear.
Remove the balancer drive gear's lock nut and flat washer.
Remove the balancer driven gear (23), spacer (24), and the
key (25).
Summary of Contents for TL 250
