34
CHAPTER 9
FORK
DISASSEMBLY
34
AB
AA
WORKSHOP MANUAL
TL 250
9.3 CHANGING FORK OIL
To change the oil, proceed as follows:
1. With the wheel removed, loosen the screws AA fastening
the leg.
2. Slide out the leg and remove the top cap AB.
3. Turn the leg upside down and allow all the oil to drain out.
4. Fill with oil (370 ml for the Casa and Competizione
models; 180 ml for the Performance models, per leg)
5. Screw the top cap AB back on.
6. Refit the leg.
7. Tighten the screws AA.
9.4
DISASSEMBLING THE FORK LEGS
This procedure is valid for both forks.
1. Remove the left fork from the vehicle, empty the oil from the
fork, and remove it from the outer tube. Next, clamp the inner
tube in a vice - using suitable protection - and heat the axle
clamp with a heat gun.
2. Now unscrew the axle clamp.
3. Remove the cartridge unit from the bottom end of the inner
tube and check that the O-ring inside the axle clamp is in its
seat and in good condition.
4. Reassemble the fork, using medium-strength Loctite on the
thread where the tube and axle clamp mate.
Summary of Contents for TL 250
