35
35
CHAPTER 10
BRAKING
SYSTEM
WORKSHOP MANUAL
TL 250
10.1 FRONT BRAKE
Check
To check front brake wear, simply inspect the caliper, looking
from the front of the bike, from where you should just be able
to make out the ends of the two pads, which should have at
least a 2mm-thick lining. Any less than this and you should
change the pads immediately.
NOTE: Perform the check at the intervals set out in the
Scheduled maintenance chart given in the owner's manual.
10.2 REAR BRAKE
Check
To check rear brake wear, simply inspect the caliper, looking
down from above, from where you should just be able to make
out the ends of the two pads, which should have at least a
2mm-thick lining. Any less than this and you should change
the pads immediately.
NOTE: Perform the check at the intervals set out in the
Scheduled maintenance chart.
Summary of Contents for TL 250
