Fanvil Technology Co., Ltd
HQ Add: Level 3, Block A, Gaoxinqi Building, Anhua Industrial Park, Qianjin 1 Road, 35th District, Bao'An, Shenzhen, 518101 P.R. China
Shenzhen Tel: +86-755-2640-2199 Fax: +86-755-2640-2618 Suzhou Tel: +86-512-6592-0605 SEA Tel: +60-3-512-21997
Email: sales@fanvil.com support@fanvil.com Beijing Tel: +86-10-5753-6809
- 40
Blue part (name)
"Group 1","Group 2" and "Group 3" are your setting monitoring multicast name.The group name will
be displayed on the screen when you answer the multicast. If you have not set, the screen will display the
IP: port directly.
Purple part (host: port)
It is a set of addresses and ports to listen, separated by a colon.
Pink part (index / priority)
Multicast is a sign of listening, but also the monitoring multicast priority. The smaller number refers to
higher priority.
Red part (priority)
It is the general call, non multicast call priority. The smaller number refers to high priority. The
followings will explain how to use this option:
The purpose of setting monitoring multicast "Group 1" or "Group 2" or "Group 3" launched a multicast
call.
All equipment has one or more common non multicast communication.
When you set the Priority for the disable, multicast any level will not answer, multicast call is rejected.
when you set the Priority to a value, only higher than the priority of multicast can come in, if you set
the Priority is 3, group 2 and group 3 for priority level equal to 3 and less than 3 were rejected, 1
priority is 2 higher than ordinary call priority device can answer the multicast message at the same
time, keep the hold the other call.
Green part (Enable Page priority)
Set whether to open more priority is the priority of multicast, multicast is pink part number. Explain
how to use:
The purpose of setting monitoring multicast "group 1" or "3" set up listening "group of 1" or "3"
multicast address multicast call.
All equipment has been a path or multi-path multicast phone, such as listening to "multicast
information group 2".
If multicast is a new "group of 1", because "the priority group 1" is 2, higher than the current call
"priority group 2" 3, so multicast call will can come in.
If multicast is a new "group of 3", because "the priority group 3" is 4, lower than the current call
"priority group 2" 3, "1" will listen to the equipment and maintain the "group of 2".
Multicast service
Send:
when configured ok, our key press shell on the corresponding equipment, equipment directly
into the Talking interface, the premise is to ensure no current multicast call and 3-way of the case, the
multicast can be established.
Lmonitor:
IP port and priority configuration monitoring device, when the call is initiated and
incoming multicast, directly into the Talking interface equipment.
