Panel
Main Body
Back Shell
Wall Bracket
Panel
Main Body
Bottom
Plate
Middle
frame
Stand
Figure 3-1
Four Major Parts of i33V
Figure 3-2
Five Major Parts of i33VF
Step 1: Installation preparation
A.Check the following contents:
Ӫ
Hex wrench x 1
Ӫ
TA5 x 40mm screws x 4
Ӫ
35mm screw anchors x4
B.Tools that may be required:
Ӫ
Hex wrench
Ӫ
Phillips screwdriver
hammer, RJ45 crimper
Ӫ
Electric impact drill with an 8mm drill bit
Step 2: Drilling
Figure 3-3
Wall Mounting / Built-in
A.Place the mounting template with dimensions on the surface of a wall in a desired flat position.
B.Use an electric drill to drill the 4 holes marked on the mounting template. It is recommended to drill
about 50mm deep. Remove the template when finishing drilling.
C.Push or hammer screw anchors into the drilled holes.
Installation
