61
DTMF
Press during a call to send the set DTMF
Mcast Paging
Configure the multicast address and voice encoding. User can initiate
multicast by pressing this key
Action URL
The user can use a specific URL to make basic calls to the device, open
the door, etc.
Mcast Listening
In standby, press the function key, if the RTP of the multicast is detected,
the device will monitor the multicast
PTT
Speed dial
:
Make a call when pressed, and end the call when lifted.
Intercom
:
Start the intercom when pressed, and end the intercom when
lifted.
Multicast
:
Initiate multicast when pressed, and end multicast when lifted
Programmable Key Settings
Desktop
None
:
Nothing happens when you press the speed dial
Dsskey1
:
When it is set to dsskey1, follow the settings of dsskey1 to make
call, answer, etc.
Dsskey2
:
When it is set to dsskey2, perform operations such as calling
and answering according to the setting of dsskey2
Dialer
None
:
Nothing happens when you press the speed dial
Dsskey1
:
When it is set to dsskey1, follow the settings of dsskey1 to make
call, answer, etc.
Dsskey2
:
When it is set to dsskey2, perform operations such as calling
and answering according to the setting of dsskey2
Ringing
Answer
:
Set to answer, when there is an incoming call, if auto answer is
disabled, press the speed dial key to answer the call
End: set to end, when there is an incoming call, press the speed dial
button to hang up the call
Talking
End: set to end, when there is a call, press the speed dial key to hang up
the call
Volume up: set as volume up button, when there is a call, press the speed
dial button to increase the volume
Volume down: set as volume up button, when there is a call, press the
speed dial button to decrease the volume
Dsskey1
:
When it is set to dsskey1, follow the settings of dsskey1 to make
call, answer, etc.
Dsskey2
:
When it is set to dsskey2, perform operations such as calling
and answering according to the setting of dsskey2
Desktop
Long
Pressed
None: Long press the speed dial key does not respond
Main menu: Long press the speed dial key to enter the command line