Com.X Administrator Guide
Page 64
on this route.
Enable
An Enable toggle. If unchecked, the rule will not be
active.
Description
An optional description for the firewall rule.
3.3.3.3 Inbound Access
An inbound access route can be configured to allow access to the Com.X device
from particular devices on the external internet.
Figure 56: Inbound access rule wizard.
Field
Description
Source Zone
In a redirect rule, the source will always be in the
internet zone, so this field has been preconfigured and
can not be edited using the rule wizard.
Source IP address
Access to this rule can be limited to a single IP address
or a range of IP addresses on the same subnet.
Source start port
The start port of the source which you would like to be
able to access this rule.
Source end point
The final port of the range of ports on the source which
you would like to be able to access this rule
Destination Zone
The allocated zone of your destination device. As this is
an inbound access rule, the zone is pre-configured to
Com.X and can not be edited from the rule wizard.
Protocol
The communication protocol that will be available on
this rule. Select between tcp and udp.
©2010 –
2016
Far South Networks
