Com.X1 PBX End User Guide
Page 12
On a digital phone, a second incoming call will be signalled on the display.
On an analog phone it will be signalled by a tone.
*70 – enable call waiting
*71 – disable call waiting
3.5 Call Pickup
Call pickup allows a user in a certain
pickup group
to pick up a call ringing on any
phone in the pickup group. The pickup groups are determined by the system
administrator.
To pickup a call in the designated pickup group, dial
*8 – pick up a call
3.6 Follow Me
Follow Me allows flexible configuration of forwarding, multiple phone ringing and
other reachability features on a per user basis.
Follow Me is configured using the PBX Web Portal (see following chapter). It may be
enabled or disabled from the phone as follows:
*21 – toggle follow me activated/deactivated – a voice prompt will read the status
3.7 Day/Night Mode
The available day/night modes control the call flow for incoming calls as configured
by the system administrator. If a password is required, it will be prompted for after
dialling the feature code.
*280 – toggle day/night mode set 0
*281 – toggle day/night mode set 1
... etc
3.8 Do Not Disturb (DND)
An extension may be set to Do Not Disturb mode. In this mode, calls will immediately
be redirected to the usual unavailable location as determined by voice mail or follow
me.
*78 – activate Do Not Disturb
*79 – deactivate Do Not Disturb
3.9 Call Trace
Call trace allows the user to obtain information about the previous call, and dial back
automatically if required. Follow voice prompts after dialling the feature code below.
*69 – call trace
3.10 Miscellaneous Features
*43 – echo test
*65 – speak your extension number
©2010 Far South Networks
